Epson XP-4100_Start-Here—Installation-Guide_pdf

Start Here IMPORTANT: Before using this product, make sure you read these instructions and the safety instructions in the online User’s Guide . Note: This printer is designed for use with Epson ® cartridges only, not third-party cartridges or ink. For important ink information, visit www.epson.com/epsonink (U.S.) or www.epson.ca/epsonink (Canada) or see your printer box. 1 Unpack Note: Do not open ink cartridge packages until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability. 1 Remove all protective materials from the product. 2 Lift up the scanner unit until it locks into place and remove all protective materials from inside the product. Caution: Do not touch the flat white cable. 3 Lift the scanner unit up slightly and lower it. When the scanner unit catches, lift it up again and lower it completely. 2 Turn on and configure 1 Connect the power cord to the back of the product and to an electrical outlet. Caution: Do not connect to your computer yet. 2 Raise the control panel and turn on the product. 3 Press or to select your language, then press OK. Note: You can change the language later using the product’s control panel. For more information, see the online User’s Guide . 3 Install ink cartridges Caution: Keep ink cartridges out of the reach of children and do not drink the ink. Note: The included initial cartridges are designed for reliable printer setup and cannot be used as replacement cartridges or resold. After setup, the remaining ink is available for printing. 1 Lift up the scanner unit until it locks into place. XP-4100/XP-4105
Page 1 of 4