Epson WorkForce Pro EC-4020 Installation Guide

Start Here IMPORTANT: Before using this product, make sure you read these instructions and the safety instructions in the online User’s Guide . Note: This printer is designed for use with Epson ® cartridges only, not third-party cartridges or ink. For important ink information, visit www.epson.com/epsonink (U.S.) or www.epson.ca/epsonink (Canada) or see your printer box. Important Safety Instructions: When using telephone equipment, you should always follow basic safety precautions to reduce the risk of fire, electric shock, and personal injury, including the following: • Do not use the Epson product near water. • Always keep this guide handy. • Avoid using a telephone during an electrical storm. There may be a remote risk of electric shock from lightning. • Do not use a telephone to report a gas leak in the vicinity of the leak. Caution: To reduce the risk of fire, use only a No. 26 AWG or larger telecommunication line cord. The illustrations show the EC-4040, but the steps are the same for all models, unless otherwise specified. 1 Unpack Note: Do not open the ink cartridge packages until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability. 1 Remove all protective materials from the product. 2 Lift up the scanner unit until it locks and remove all protective materials from inside the product. 3 Lower the scanner unit. 2 Turn on and configure 1 Connect the power cord to the back of the product and to an electrical outlet. Caution: Do not connect to your computer yet. 2 Raise the control panel and turn on the product. 3 Select your language, country, and time. Note: You can change these settings later using the product’s control panel. For more information, see the online User’s Guide . EC-4020/EC-4030/EC-4040 Series
Page 1 of 4

Leave a Reply