Epson-LabelWorks-LW-400_User-s-Guide_pdf

Display settings You can adjust the following display settings: Backlight: Turns the backlight of the display on or off. Contrast: Adjusts the density of the fonts on the display. (Value: -5 to +5) Language: Changes the language of the settings and messages on the display. inch:cm: Selects the unit of measurement for length. To adjust display settings, follow the steps below: 1. Press to turn on the product. 2. Press + . 3. Press or to highlight a setting, then press to select it. 4. Press or to select setting options, then press . Setup This product operates with batteries (not included) or with an AC adapter (not included). Inserting batteries 1. Remove the rear cover. 2. Insert 6 AA alkaline batteries. Note: If you need to install a tape cartridge, see “Inserting a tape cartridge” below. 3. Replace the cover and snap it into place. Optional AC adapter (APT0615Z1-1) Warning: Make sure to use AC adapter APT0615Z1-1 or damage may occur. 1. Plug one end of the AC adapter into the product. 2. Plug the the other end of the AC adapter into the wall outlet. Inserting a tape cartridge 1. Remove any slack from the ink ribbon. 2. Remove the rear cover, if necessary. 3. nsert the tape cartridge and press it down firmly until it snaps into place. If there is excess tape, feed the end of the tape through the tape guide slot. 4. Replace the cover and snap it into place. Preparing the tape After inserting a tape cartridge, make sure to feed some tape through the tape guide slot to position it for printing. 1. Press to turn on the product. 2. Press + . Button names and functions 1 2 3 4 5 7 8 9 11 12 13 14 15 16 17 18 19 20 21 22 23 10 1. Power 2. Font 3. Font size 4. Frame 5. Font style 6. Settings 7. Character keys 8. Shift key 9. Caps lock 10. Accent 11. Space 12. Shift key 13. Select/Enter 14. Punctuation 15. Delete ( 16. Symbols 17. Special formats 18. Print copies 19. Preview 20. Cursor keys ( previous or next label) 21. Print ( 22. Cut button 23. Display + deletes all text) + , + goes to + feeds the tape) Turning the power off Press to turn off the power. If using an AC adapter, disconnect it from the wall outlet and the product. If batteries are inserted, remove them only if the product will not be used for a long period of time. Display indicators Indicators on the display show whether or not settings are enabled. 1 2 3 4 5 6 7 8 9 10 11 1. Font size 2. Font width 3. Frame 4. Font style 5. Vertical text 6. Battery level 7. Accent mark options 8. Upper/lower case 9. Cursor (blinks to indicate current position) 10. Line number (appears when multiple lines exist) Note: You can print up to four lines of text. 11. Label number (you can save up to 50 labels) Read these instructions before using your product. User’s Guide
Page 1 of 8