Epson-LabelWorks-LW-300_User-s-Guide_pdf

Read these instructions before using your product. User’s Guide Button names and functions 1 2 3 4 5 6 7 8 9 11 10 12 13 14 15 16 17 18 19 20 21 1. Power 2. Font 3. Font size 4. Font style 5. Settings 6. Character keys 7. Shift key 8. Caps lock 9. Accent 10. Space 11. Shift key 12. Select/Enter 13. Punctuation 14. Symbols 15. Delete ( 16. Preview 17. Print copies 18. Cursor keys ( next label) 19. Print ( 20. Cut button 21. Display Turning the power off Press to turn off the power. If using an AC adapter, disconnect it from the wall outlet and the product. If batteries are inserted, remove them only if the product will not be used for a long period of time. Display indicators Indicators on the display show whether or not settings are enabled. + deletes all text) + , + goes to previous or + feeds the tape) 1 7 8 6 9 2 3 4 5 10 11 1. Font size 2. Font width 3. Frame 4. Font style 5. Vertical text 6. Battery level 7. Cursor (blinks to indicate current position) 8. Line number (appears when multiple lines exist) Note: You can print up to two lines of text. 9. Accent mark options 10. Upper/lower case 11. Label number (you can save up to 30 labels) *412092100* Display settings You can adjust the following display settings. Contrast: Adjusts the density of the fonts on the display. (Value: -5 to +5) Language: Changes the language of the settings and messages on the display. inch:cm: Selects the unit of measurement. To adjust display settings, follow the steps below: 1. Press to turn on the product. 2. Press + . 3. Press or to highlight a setting, then press to select it. 4. Press or to select setting options, then press . .Setup This product operates with batteries (not included) or with an AC adapter (not included). Inserting batteries 1. Remove the rear cover. 2. Insert 6 AAA alkaline batteries. Note: If you need to install a tape cartridge, see “Inserting a tape cartridge” below. 3. Replace the cover and snap it into place. Optional AC adapter (APT0615Z1-1) Warning: Make sure to use AC adapter APT0615Z1-1 or damage may occur. 1. Plug one end of the AC adapter into the product. 2. Plug the other end of the AC adapter into the wall outlet. Inserting a tape cartridge 1. Remove any slack from the ink ribbon. 2. Remove the rear cover, if necessary. 3. nsert the tape cartridge and press it down firmly until it snaps into place. If there is excess tape, feed the end of the tape through the tape guide slot. 4. Replace the cover and snap it into place. Preparing the tape After inserting a tape cartridge, make sure to feed some tape through the tape guide slot to position it for printing. 1. Press to turn on the product. 2. Press + . 3. Press the Cut button to cut the tape.
Page 1 of 8