Epson ET-M3170_Start-Here—Installation-Guide_pdf

Start Here IMPORTANT: Before using this product, make sure you read these instructions and the safety instructions in the online User’s Guide . Important Safety Instructions: When using telephone equipment, you should always follow basic safety precautions to reduce the risk of fire, electric shock, and personal injury, including the following: • Do not use the Epson ® product near water. • Always keep this guide handy. • Avoid using a telephone during an electrical storm. There may be a remote risk of electric shock from lightning. • Do not use a telephone to report a gas leak in the vicinity of the leak. Caution: To reduce the risk of fire, use only a No. 26 AWG or larger telecommunication line cord. 1 Unpack Make sure you keep the box shown above for use when transporting the printer. Caution: Do not lift the product by gripping the scanner unit. Make sure you lift using the handholds on the bottom of the product. Note: Do not open the ink bottle until you are ready to fill the ink tank. The ink bottle is vacuum packed to maintain reliability. 1 Lift the printer cover until it clicks into place. 2 Remove all protective materials from the product. Caution: Do not touch the flat white cable, translucent film, or the ink tubes. 3 Close the printer cover. Note: Do not connect the power cord yet. 2 Fill ink tank and charge the ink Warning: Keep the ink bottle out of the reach of children and do not drink the ink. Caution: This product requires careful handling of ink. If ink spills, wipe it off immediately with a damp towel to avoid permanent stains. If ink gets on your clothes or belongings, it may not come off. Note: • Epson cannot guarantee the quality or reliability of third-party ink. • Use the ink bottle included with the printer to set up the product. Part of the ink will be used to charge the print head. This bottle may print fewer pages compared with replacement ink bottles. 1 Open the ink tank cover, then open the cap. 2 Unpack the ink bottle. Hold the ink bottle upright and slowly turn the bottle cap to remove it. Caution: Do not shake or squeeze the ink bottle. Do not touch the top of the ink bottle after its cap is removed. 3 nsert the ink bottle into the filling port, as shown below. Note: Do not force the bottle into position. ET-M3170
Page 1 of 4

Leave a Reply