Epson ET-5850_Start-Here—Installation-Guide_pdf

IMPORTANT: Before using this product, make sure you read these instructions and the safety instructions in the online User’s Guide . Important Safety Instructions: When using telephone equipment, you should always follow basic safety precautions to reduce the risk of fire, electric shock, and personal injury, including the following: • Do not use the Epson ® product near water. • Always keep this guide handy. • Avoid using a telephone during an electrical storm. There may be a remote risk of electric shock from lightning. Do not use a telephone to report a gas leak in the vicinity of the leak. Caution: To reduce the risk of fire, use only a No. 26 AWG or larger telecommunication line cord. The illustrations show the ET-5800, but the steps are the same for all models, unless otherwise specified. 1 Unpack Note: Do not open the ink bottles until you are ready to fill the ink tanks. The ink bottles are vacuum packed to maintain reliability. 1 Remove all protective materials from the product. 2 Lift up the scanner unit. Remove all protective materials from inside the product. Caution: The printer ships with the transportation lock in the printing position. Do not move it from the printing position. 3 Lower the scanner unit. 2 Fill ink tanks Warning: Keep the ink bottles out of the reach of children and do not drink the ink. Caution: This product requires careful handling of ink. If ink spills, wipe it off immediately with a damp towel to avoid permanent stains. If ink gets on your clothes or belongings, it may not come off. Note: • Epson cannot guarantee the quality or reliability of third-party ink. • Use the ink bottles included with the printer to set up the product. • The included ink bottles are designed for reliable printer setup and cannot be resold. Epson recommends the use of Genuine Epson T542 pigment inks. The use of any other inks may cause damage not covered by the warranty, particularly if they are not pigment. Epson cannot guarantee that non-Epson T542 inks are pigment, even if labeled as compatible. 1 Open the ink tank cover, then open the cap for the black ink tank. Note: Refer to the color-coded sticker on the ink tank unit to identify the color of each tank. 2 Unpack the black (BK) ink bottle. Hold the ink bottle upright and slowly turn the bottle cap to remove it. Caution: Do not shake or squeeze the ink bottles. Do not touch the top of the ink bottle after its cap is removed. Start Here ET-5800/ET-5850/ET-5880
Page 1 of 4

Leave a Reply