Epson ET-4500_Start-Here—Installation-Guide_pdf

Start Here 2 Fill ink tanks Note: This product requires careful handling of ink. Wear disposable gloves and place a sheet of paper under the ink tank unit when you fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off immediately with a damp towel to avoid permanent stains. If ink gets on your clothes or belongings, it may not come off. Warning: Keep the ink bottles out of the reach of children and do not drink the ink. 1 Open the ink tank unit cover, then remove the cap for the cyan ink tank and attach it to its holder. 1 2 3 2 Unpack the cyan ink bottle. 3 Snap the bottle tip off, then remove the bottle cap. Carefully remove the protective seal (avoid touching the ink underneath the seal), then close the bottle cap tightly. Caution: Be sure to close the bottle cap tightly, or ink may leak. 4 Fill the tank using all of the ink in the bottle. Note: Refer to the color coded sticker above the ink tank unit to identify the color of each tank. Caution: Be sure to fill each tank with the correct ink color. 5 Carefully seal the bottle using the reverse side of the bottle tip for proper disposal. ET-4500 Read these instructions before using your product. Note for Spanish speakers/Nota para hispanohablantes: Para obtener instrucciones de configuración en español, consulte la Guía de instalación en (requiere una conexión a Internet). 1 Unpack French control panel sticker Note: Do not open the ink bottles until you are ready to fill the ink tanks. The ink bottles are vacuum packed to maintain reliability. 1 Remove all protective materials from the product. 2 Lift up the scanner unit and remove all protective materials from inside the product. 1 2 Caution: Do not touch the flat white cable or the ink tubes and their translucent cover. 3 Lower the scanner unit.
Page 1 of 4

Leave a Reply