Epson ET-2600_Start-Here—Installation-Guide_pdf

Start Here Read these instructions before using your product. Note for Spanish speakers/Nota para hispanohablantes: Para obtener instrucciones de configuración en español, consulte la Guía de instalación en www.epson.com/support/et2600sp (requiere una conexión a Internet). 1 Unpack Note: Do not open the ink bottles until you are ready to fill the ink tanks. The ink bottles are vacuum packed to maintain reliability. Ink bottle design may vary. 1 Remove all protective materials from the product. 2 Lift up the scanner unit and remove all protective materials from inside the product. Caution: Do not touch the flat white cable or the ink tubes and their translucent cover. 3 Lower the scanner unit. 2 Fill ink tanks Note: This product requires careful handling of ink. Wear disposable gloves and place a sheet of paper or plastic under the ink tank when you fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off immediately with a damp towel to avoid permanent stains. If ink gets on your clothes or belongings, it may not come off. Warning: Keep the ink bottles out of the reach of children and do not drink the ink. 1 Open the ink tank cover, then remove the cap for the black ink tank and attach it to its holder. 2 Unpack the black ink bottle. 3 Depending on the ink bottle included with your product, snap off the bottle tip or unscrew the lid. 4 Remove the bottle cap. Carefully remove the protective seal (avoid touching the ink underneath the seal), then close the bottle cap tightly. Caution: Be sure to close the bottle cap tightly, or ink may leak. ET-2600
Page 1 of 4

Leave a Reply