Epson ET-16600_Start-Here—Installation-Guide_pdf

Start Here IMPORTANT: Before using this product, make sure you read these instructions and the safety instructions in the online User’s Guide . Important Safety Instructions: When using telephone equipment, you should always follow basic safety precautions to reduce the risk of fire, electric shock, and personal injury, including the following: • Do not use the Epson ® product near water. • Always keep this guide handy. • Avoid using a telephone during an electrical storm. There may be a remote risk of electric shock from lightning. Do not use a telephone to report a gas leak in the vicinity of the leak. Caution: To reduce the risk of fire, use only a No. 26 AWG or larger telecommunication line cord. The illustrations show the ET-16600, but the steps are the same for all models, unless otherwise specified. 1 Unpack Note: Do not open the ink bottles until you are ready to fill the ink tanks. The ink bottles are vacuum packed to maintain reliability. 1 Remove all protective materials from the product. 2 Lift up the scanner unit. Remove all protective materials from inside the product. Caution: Do not touch the flat white cable or the ink tubes and their translucent cover. Do not move the transportation lock from the printing position. 3 Lower the scanner unit. 2 Fill ink tanks Warning: Keep the ink bottles out of the reach of children and do not drink the ink. Caution: This product requires careful handling of ink. If ink spills, wipe it off immediately with a damp towel to avoid permanent stains. If ink gets on your clothes or belongings, it may not come off. Note: • Epson cannot guarantee the quality or reliability of third-party ink. • Use the ink bottles included with the printer to set up the product. • The included ink bottles are designed for reliable printer setup and cannot be resold. 1 Open the ink tank cover, then open the cap for the black ink tank. Note: Refer to the color-coded sticker on the ink tank unit to identify the color of each tank. 2 Unpack the black (BK) ink bottle. Hold the ink bottle upright and slowly turn the bottle cap to remove it. Caution: Do not shake or squeeze the ink bottles. Do not touch the top of the ink bottle after its cap is removed. 3 nsert the ink bottle into the filling port. Note: Do not force the bottles into position; they are keyed for each color. ET-16600/ET-16650
Page 1 of 4

Leave a Reply