Epson ET-16500_Start-Here—Installation-Guide_pdf

Start Here Read these instructions before using your product. Nota para hispanohablantes/Note for Spanish speakers: Para obtener instrucciones de configuración en español, consulte la Guía de instalación en www.epson.com/support/et16500sp (requiere una conexión a Internet). 1 Unpack French control panel stickers Note: Your product includes 4 Initial ink bottles that are designed for product setup and 4 additional full-size bottles for refilling. These bottles are not for resale. Do not open the ink bottles until you are ready to fill the ink tanks. The ink bottles are vacuum packed to maintain reliability. 1 Remove all protective materials from the product. 2 Lift up the scanner unit and remove all protective materials from inside the product. Caution: Do not touch the translucent part or ink tubes. 3 Lower the scanner unit. 2 Fill ink tanks Note: This product requires careful handling of ink. Wear disposable gloves and place a sheet of paper or plastic under the ink tank when you fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off immediately with a damp towel to avoid permanent stains. If ink gets on your clothes or belongings, it may not come off. Warning: Keep the ink bottles out of the reach of children and do not drink the ink. 1 Open the ink tank unit cover, then remove the cap for the black ink tank and attach it to its holder. 2 Unpack the black Initial ink bottle. 3 Snap the bottle tip off, then remove the bottle cap. Carefully remove the protective seal (avoid touching the ink underneath the seal), then close the bottle cap tightly. Caution: Be sure to close the bottle cap tightly, or ink may leak. 4 Fill the tank using all of the ink in the bottle. Note: Refer to the color-coded sticker above the ink tank unit to identify the color of each tank. Caution: Be sure to fill each tank with the correct color. 5 Carefully seal the bottle using the reverse side of the bottle tip for proper disposal. ET-16500
Page 1 of 4

Leave a Reply